1. Remove the water, grease, dust and other pollutants on the joint surface, clean the surface with solvent (such as xylene, butanone) when appropriate, and then wipe all residues with a clean cloth to make it fully clean and dry.
2. Cover the surface near the interface with plastic tape. To ensure that the sealing work line is perfect and tidy.
3. Cut the opening of the rubber tube, install the spigot tube, and then cut it at an angle of 45 ° according to the caulking size.
4. Install the glue gun and press out the glue along the gap at an angle of 45 ° to ensure that the glue is in close contact with the substrate surface. When the width of the joint is greater than 15 mm, it is necessary to apply glue repeatedly. After gluing, trim the surface with a knife, remove the excess glue, and then tear off the tape. If there is any stain, it can be removed with a wet cloth.
5. The surface of sealant will be vulcanized after 10 minutes at room temperature. It will take 24 hours or longer for the sealant to be fully vulcanized, depending on the thickness of the sealant and the temperature and humidity of the environment.
1. First you need to be able to use a glue gun.
2. Determine the width of the glass glue you apply, that is, the gap width.
3. According to the width of the gap, cut the glue mouth into smaller caliber than the gap.
4. Do a good job in the protection of both sides of the crack. Paste 2-3cm type adhesive paper on the glass, profile, stone, etc. on both sides of the crack to protect the glass, profile, stone, etc. on both sides. It is also very convenient to correct the glue in the crack.
5、 Master the speed of glass glue and the moving speed of glue gun, and move the glue gun evenly according to the depth of the gap.
6. Repair the glass glue area, find a blade to smooth the uneven area, and make up for the area where there is no gap when applying the glue.
7. After 48 hours, the tape on both sides of the material will be removed to complete the construction.
1. Use the glass glue in the place with good ventilation environment. After use, the window must be opened to keep the ventilation, so that the harmful gas can be emitted quickly.
2. Avoid contact with skin, etc. to avoid glass glue into the eyes, so when using glass glue, use a protective cover to prevent glass glue from entering the eyes.
3. When using glass glue, wear a mask. When using glass glue, wear a mask, so as to avoid harmful gas from inhaling into the body.
4. Don't let children contact after using the glass glue, pay attention to close well, and put it in the place that children can't reach. The above content is how to make the glass glue that this small edition brings to you?
The usage and precautions of glass glue are introduced for your reference. I believe you will have a certain understanding of how to use glass glue after reading this article. I hope you can provide some help to the friends who need to use glass glue for decoration.
Copyright 2012-2022 (C) Zhejiang Time New Materital Co.,Ltd. All Right Reserved.